Pay attention to the following three issues when installing seals:
1. Do not damage the sealing surface on the surface of the seal or the plane surface of the sealing line. The sealing performance of the seal relies on the inner holes of the two polytetraoxide plates on the left and right. The sealing performance of the hydraulic seal depends on the lip line related to the hole or shaft. These parts are made of high-purity stone eggs that are both soft and resilient and are resistant to high temperatures, corrosion, and aging. They are also made of vulnerable materials such as plastic products and chemical fibers. Therefore, they need to be transported, installed, and stored during the entire process. Special maintenance and care must be given to the sealing part. Once damaged, the sealing part will often be left with a huge safety hazard;
2.Cannot force installation
Some seals are placed in groove-shaped ferrule joints. At this time, they must be installed tightly. The construction must be smooth and rough. Forcing a PTFE gasket with a very large posture will inevitably damage the original prefabricated structure of the seal. , just like prefabricating and crushing the concrete and then filling in the required parts will inevitably cause cross sticks. You must be very careful when installing this kind of seal. The insertion must be carried out layer by layer multiple times:
3. Pay attention to balance and symmetry when installing
Place the seal exactly around the effective sealing surface (or orifice line). After the gasket manufacturer's system is put into use, further observation and tight sealing treatment are required to avoid system work. Failures caused by micro-leakage may occur due to changes in working conditions (such as increase) during the process.
Seals must be stored properly when not needed temporarily
1. Anti-brittle, shading, waterproof, place flat, away from cold and heat sources:
2. Do not apply pressure to keep the seal in a natural and loose state. Applying external force will change its physical shape: